1. Check that it is safe to start

If there is active flooding, sewage or unknown contamination, structural movement, unsafe access, or possible gas or electrical involvement, stop here and use the flood-safety guide. Do not energise wet or suspect circuits.

2. Stop the leak and remove standing water

Isolate or repair the source through the appropriate trade. Remove standing clean water only when access and utilities are safe. A dehumidifier is for moisture in the air; it is not a pump for water on the floor.

3. Work out where the water travelled

Check the visible room, the level below and nearby rooms. Water can move behind skirtings, under flooring and into cavities or insulation. Photograph and label the affected areas before you change the setup.

4. Choose one main drying approach

Either open the room for ventilation when outdoor conditions and safety allow, or close the outside doors and windows while a dehumidifier runs. Do not use both approaches at the same time as the default. NI Direct: After a flood, clearing up

5. Move air across wet surfaces

A fan or air mover can reduce still air at a surface, but it does not remove water from the building. Follow the equipment instructions, keep guards clear and make sure the air reaches the area you intend to dry. Never run a petrol or diesel generator indoors to power fans or heaters; carbon monoxide can kill.

6. Measure the same spots each time

Choose named points, for example the lounge skirting below the window and the wall beside the door. Record the time, temperature, RH, meter and equipment state, then return to the same spots for the next reading. The drying log can keep two readings together for comparison.

7. Decide when to check again

If readings stall, rise or vary unexpectedly, recheck the leak, room boundaries, equipment and possible hidden routes. Before you redecorate or lay flooring, follow the moisture requirement for that finish or ask a qualified professional.

8. Choose or hire equipment

Once the source and hazards are dealt with, the National Tool Hire Climate and Ventilation range is one UK place to inspect dehumidifier and fan hire. National Tool Hire did not write or check this guide. Confirm the exact equipment, electrical supply, drainage and instructions before booking.